Reverb can simulate sound reflecting in a room or an environment. To start off, you can select a preset in Simple-mode. If you want to tweak the effect, you can switch off Simple-mode and adjust properties to your liking. Remember, if you re-enable Simple-mode, the properties will be reset to the preset values.
Enabled
Determines if the effect is active
Simple
Preset mode
Global
If enabled, distance doesn't affect the reverb effect
Preset
In simple mode, there are a variety of presets to choose from
Advanced mode properties
Decay Time
Reverberation decay time
Early Delay
Initial reflection delay time
Late Delay
Late reverberation delay time relative to initial reflection
HF Reference
Reference high frequency
HF Decay Ratio
High-frequency to mid-frequency decay time ratio
Diffusion
Value that controls the echo density in the late reverberation decay
Density
Value that controls the modal density in the late reverberation decay
Low Shelf Freq
Reference low frequency
Low Shelf Gain
Relative room effect level at low frequencies
High Cut
Relative room effect level at high frequencies
Early Late Mix
Early reflections level relative to room effect
Wet Level
Room effect level at mid frequencies
Non-global mode properties
Min Distance
Distance where the effect starts to fade away
Max Distance
Distance where the effect has faded out completely